| The main points of the installation, debugging and use of the turning machine
The main points of the installation, debugging and use of the turning machine
CATEGORY:
CREATED:
Dec 30, 2021
The main points of the installation, debugging and use of the turning machine
1. Installation of turning machine:
1. The turning machine equipment is placed in the corresponding pit, the pit surface is required to be flat, and the working surface of the turning machine is kept level with the ground.
2. Turn on the power of the turning machine according to the circuit drawing, and confirm whether it has been reliably grounded.
3. Adjust the level of the turning machine to make the turning machine in a horizontal state.
4. Check and confirm whether the positions of the switches of the turning machine are appropriate and firm.
2. The use of turning machine:
1. Please check the reliability of the external power supply and grounding wire of the turning machine before use.
2. Turn on the "Total Power" and "Emergency Stop" switches of the turning machine, and the "Power Indication" light is on at this time.
3. Restore the turning machine to its original state. That is, the flip body is in the "reset" state.
4. After the above basic steps are completed, follow-up operations can be carried out.
5. Use a spreader or forklift to move the product to the center of the working surface of the turning body. This process should be operated carefully to prevent the product from colliding with the turning body during the movement.
6. Rotate the flip switch until the flip is over and let go.
7. Use a forklift to move the product out of the turning body steadily. Pay attention to safety during this process to prevent the product from colliding with the turning machine.
8. After the product is safely and completely removed from the flip body, operate the flip switch to reset the flip body and prepare for the next operation.
9. Repeat the above operations for the next job.
